Product Show >> Hydraulic Solenoid Valve >> Direct-action Proportional Solenoid


Direct-action Proportional Solenoid

Direct-action Proportional Solenoid

Detail About Direct-action Proportional Solenoid

1. For installation, use screws with a tensile strength of greater than 85kg/mm2 (Available upon purchase).

2. Inlet O-Ring must fully comply with GB1325-76 Standards.

3. Notes For Plug Us

a) Remove the hollow crew from inside the cover, tighten it again after

wire is connected to the base.

b) A rubber ring is provided at cable entrance, the plug wiring will be

tightly clamped when the threaded cover is tightened.

(Note: 3-wire cable should be used for connection)