Product Show >> Hydraulic Solenoid Valve >> Explosion isolation solenoid relief valve


Explosion isolation solenoid relief valve

Explosion isolation solenoid relief valve

Detail About Explosion isolation solenoid relief valve

1.The manual push rod at the end may be used during hydraulic system testing,with automatic reset functions.
2.For installation, use screws with a tensile strength of greater than 85kg/mm2 (Available at the time of purchase).
3.Inlet O-Ring must fully comply with Gb1325-76 Standards.
4.Remove the cover, tightenm it again after wiring to the base. There is a rubber ring at the cover wire entrance, when the threaded cover is tightened, wiring in the plug will be tightly clamped.
5.Cable must comply with explosion-proof requirements